Device: ANV32AA1W (ISP)
Manufacturer: Anvo-Systems
Part number description for this device:
Move the cursor over the box to highlight particular section| ANV | ||
| X | Memory Type | 3 = Serial nvSRAM |
| X | Store Type | 1 = Instruction 2 = Power store 3 = Cap store 4 = Non-volatile write |
| X | Version | A = A version B = B version C = C version D = D version E = E version |
| X | Density | 6 = 64Kb 8 = 256Kb 9 = 512Kb A = 1Mb |
| X | Interface | 1 = SPI 2 = I2C |
| X | Power Supply | A = 3.3V to 3.6V W = 2.7V to 3.6V |
| X | Package Type | D = Plastic 8-pin 5x6 DFN M = Plastic 8-pin 5x6 MLP S = Plastic 8-pin 150 mil SOIC/SOP T = Plastic 16-pin 169 mil TSSOP |
| X | Temperature Range | A = Automotive (-40°C to 125°C) E = Extended (-40°C to 105°C) C = Commercial (0°C to 70°C) K = Industrial (-40°C to 85°C) |
| XX | Clock Rate | 66 = 66MHz |
| X | Lead Finish | Blank = 100\\% Sn (Matte Tin) |
Note: Part number description table describes usual part-numbering system for more chips, therefore this table can contain information, that might not be valid for the actually selected chip. The information here are provided on the best-effort basis and might be either inaccurate or incoplete. Therefore always check the latest datasheet of the chip for part number description detail. If you find some inaccuracy, let us please know.
go back to result pageSupported by programmers and programming adapters/modules:
| BeeHive204 | adapter/module: Note: via ISP connector |
| BeeHive204AP | adapter/module: Note: via ISP connector |
| BeeHive208S | adapter/module: Note: via ISP connector |
| BeeProg2 | adapter/module: Note: via ISP connector |
| BeeProg2AP | adapter/module: Note: via ISP connector |
| BeeProg2C | adapter/module: Note: via ISP connector |
| BeeHive204AP-AU (discontinued) | adapter/module: Note: via ISP connector |
| SmartProg2 (discontinued) | adapter/module: Note: via ISP connector |
